Upkeep Handbook of your Laser Engraving Machine

  1. Stuffing lubricating gas to linear guide

As we know, the light up and dirt which can be produced by the engraving and cutting will harm the manual rail right after a time period of consumption, so we have to do the everyday upkeep of the guide rail. Make sure you switch off the laser engraving machine and minimize the energy, nice and clean the manual rail with nice and clean mull, then please decrease the lubricating essential oil about the manual rail, try and move the slide rod and be sure that the oil makes it.

laser machine

 

  1. Thoroughly clean the reflector and concentrating mirror

Soon after a time period of utilization of the laser engraving and laser cutting machine, the light up and dust will follow the top of the reflector and looking glass, which will affect the engraving and cutting level and also will affect the engraving and cutting preciseness. We should thoroughly clean three of the reflectors and something paying attention mirror with natural alcoholic drinks weekly.

  1. Essential oil-filling for your showing

A laser engraving unit comes with a lot of bearings, to help keep the good engraving and cutting final result, component of bearings should be filled with oils regularly (except the gas-keeping displaying). Wipe away from the surface area dust particles about the showing using the nice and clean mull, get a sheet of injector and suck some motor essential oil within, then fill up the bearing with pinhead and relocate the bearing at the same time.

  1. Change of synchronous buckle

There are some synchronous belts using one سایت ایران روتک, if the synchronous belt is way too loosened resulting from the double graphics of the engraved words, in the event the synchronous buckle is just too limited resulting within the abrasion of synchronous buckle.

  1. Maintenance of the laser pipe

The laser tube of your laser engraving machine is utilizing the cycle normal water as cooling system and as the time continues, there will be some furings in the laser tubing. We could set just a little white vinegar in to the routine h2o; the vinegar will dissolve the furing. After that, we will apply certain water that is clean to completely clean the pipe. Hence the laser hose will be in the best operating issue as well as its daily life will end up for a longer time.